BPS-BPA酚醛环氧树脂的合成及其应用性能

Synthesis and application properties of BPS-BPA phenolic epoxy resin

摘要:

以双酚A酚醛树脂(BPA酚醛树脂)和4,4-二羟基二苯砜(BPS)为原料，环氧氯丙烷为桥连剂，在四丁基溴化铵(TBAB)的催化作用下合成了BPS-BPA酚醛环氧树脂(目标产物)。采用FTIR、1H NMR、GPC、能谱分析等对产物的化学结构和分子量进行表征，结果表明目标产物成功制备，其Mw为4355且表现出较好的耐温性能，此外还探讨了反应温度、反应时间、物料配比、NaOH用量等因素对目标产物环氧值的影响。利用正交实验设计获得了目标产物的最佳工艺条件为：反应温度110℃，反应时间2.5h，物料配比1:0.9，NaOH用量18ml。此条件下合成产物的环氧值为0.718%。最后向目标产物中加入固化剂，得到的胶黏剂具有优良的粘结性能，其最大粘结力达100.66 N，层间结合强度0.788 N.m，对低极性聚丙烯材料具有很好的附着性能。

Abstract:

Bisphenol S-BPA phenolic epoxy resin was synthesized using bisphenol A phenolic resin (BPA phenolic resin) and 4, 4-dihydroxydiphenyl sulfone (BPS) under the bridge of epichlorohydrin and the Catalysis of tetrabutylammonium bromide (TBAB). Then, its chemical structure and molecular weight were character-ized by FTIR, 1H NMR, GPC, energy spectrum analysis, etc. The results showed that the target product was successfully prepared and showed good temperature resistance, and its Mw was 4355. In addition, the effects of reaction temperature, reaction time, material ratio and NaOH content on the epoxy value of the target product were also discussed. The optimum process conditions for the target product obtained by or-thogonal experimental design are: reaction temperature 110 ?C, reaction time 2.5 h, material ratio 1:0.9, NaOH content 18 ml. Under these conditions, the epoxy value of the synthesized product was 0.718%. Finally, an adhesive was obtained by adding a curing agent to the target product. This adhesive has excel-lent bonding properties. It displays a maximum adhesion of 100.66 N and an interlayer bonding strength of 0.788 N.m, which exhibits good adhesion to low-polarity polypropylene materials.